Metal Roofing in Murray, UT

Standing seam

Vertical panels joined by raised seams with the fasteners hidden underneath. Nothing penetrates the weather surface, which is why it lasts. It is also the most expensive and the least forgiving to install — this is not a system to hire cheaply.

Exposed fastener (corrugated, R-panel, ribbed)

Screws go through the face of the panel into the deck, with a rubber washer sealing each one. Far cheaper, faster, and completely legitimate on shops, garages, and outbuildings. The washers do degrade and the screws need attention every 10 to 15 years.

Stone-coated steel

Steel panels with a granular coating that reads as shingle or tile from the ground. Metal durability with a conventional look, priced between the two above. Popular where an HOA restricts panel appearance.

Smaller footprints near the historic center keep totals low. The variable is original 1x plank decking, which sometimes needs sheathing over before shingles go on.

That range assumes a complete tear-off, synthetic underlayment, ice-and-water shield at the eaves and valleys, new flashing, and ridge ventilation. A quote materially below it is usually missing one of those, not finding a cheaper shingle.

Reasons it makes sense in the Salt Lake Valley

• It sheds snow rather than holding it, which reduces ice damming on bench and canyon-mouth homes
• Excellent wind performance on exposed lots — standing seam in particular
• Non-combustible, which matters on wildland-interface properties
• Reflective coatings cut summer attic heat gain meaningfully
• A 50-year service life is realistic, not marketing

Reasons we sometimes talk people out of it

• Two to three times the up-front cost of architectural shingle
• You will not stay long enough to reach the break-even point if you are moving inside ten years
• Snow shedding is a hazard if the roof drains over a walkway, driveway, or entry — snow guards become mandatory, not optional
• Complex rooflines with many valleys and dormers get expensive fast in standing seam
• A poorly installed metal roof is worse than a well-installed shingle roof, and there are fewer crews here who do it properly

For a typical 24-square valley home, that puts a residential standing seam roof somewhere in the $29,000 to $48,000 range, against roughly $11,000 to $18,000 for architectural shingle. Exposed-fastener panel on a detached shop is usually $3,500 to $9,000.

Murray central has a lot of small, older homes where the roof area is modest and the cost of a full replacement lands well under the valley average. Those same homes frequently have original 1x boards for decking, which changes what a tear-off actually costs.

Mature trees through the older Murray neighborhoods drop enough debris to keep valleys and gutters loaded, and that trapped moisture is the most common cause of premature decking rot we find here.

Housing here is older cottages and bungalows near the historic center, 1960s–80s ranches in between, and newer townhome infill along State Street. We work throughout Murray Downtown, the Vine Street area, the Fashion Place area, the State Street corridor, and the rest of Murray — including everything near Fashion Place Mall.

ZIP codes we serve in Murray: 84107, 84121, 84123.

There are two, they cover different things, and only one of them is about us.

• Manufacturer warranty — covers defects in the shingle itself. Usually 25 to 50 years, prorated, and rarely the thing that fails. Most manufacturer warranties are voided by inadequate attic ventilation, which is why we will not skip that step.
• Workmanship warranty — covers the installation. This is the one that matters, because the overwhelming majority of premature roof failures are installation errors, not material defects. Ours is written, transferable to a buyer, and backed by a company that has been in the valley since 2011.
• Enhanced manufacturer system warranties — available when the full system (underlayment, starter, field, ridge, ventilation) comes from one manufacturer and is installed by a certified contractor. These can cover workmanship too. Ask whether you qualify.

We work throughout Murray — Murray Downtown, the Vine Street area, the Fashion Place area, the State Street corridor — and everything around Fashion Place Mall, Murray Park, Intermountain Medical Center. Murray has roughly 50,000 residents and sits in Salt Lake County.

Mature trees through the older Murray neighborhoods drop enough debris to keep valleys and gutters loaded, and that trapped moisture is the most common cause of premature decking rot we find here.