Roofing in Draper, UT

• Roof certifications for real estate transactions
• Leak diagnosis and repair — including the leaks two other companies could not find
• Full tear-off and replacement in asphalt, metal, and tile
• Storm, wind, and hail damage assessment, with insurance claim documentation
• Flashing, valley, chimney, and skylight work
• Ridge and intake ventilation correction
• Attic ice dam mitigation on bench and canyon-mouth homes
• Low-slope and flat sections in TPO, EPDM, and modified bitumen
• Detached garage, shop, and outbuilding roofs
• Gutter and fascia repair as part of a roof project

The most complex rooflines we work on. Multiple intersecting gables, dormers, and long valleys mean far more flashing and labor per square than the size alone suggests.

That range assumes a complete tear-off, synthetic underlayment, ice-and-water shield at the eaves and valleys, new flashing, and ridge ventilation. A quote materially below it is usually missing one of those, not finding a cheaper shingle.

Draper has the most complicated rooflines we work on. Multiple intersecting gables, dormers, and long valleys mean more linear feet of flashing and more places for water to find a way in — and it means a square-foot price quoted over the phone is close to meaningless here.

SunCrest and Traverse Ridge sit high enough to see materially more snow and much stronger wind than the valley floor, and wind uplift ratings genuinely matter on those homes.

Housing here is larger two-story and custom homes, many with complex rooflines, multiple dormers, and steep pitches. We work throughout SunCrest, Corner Canyon, Draper Heights, Steeplechase, and the rest of Draper — including everything near Corner Canyon.

ZIP codes we serve in Draper: 84020.

This is the question that decides whether you spend $600 or $16,000, and it is where most homeowners get pushed. Here is the framework we use, and you can apply it to anyone's quote.

Repair is the right call when

• The roof is under about 15 years old and the rest of the field looks uniform
• The damage is localized — one slope, one valley, one penetration
• Granule loss is confined to areas under trees or downspouts, not spread across a whole plane
• A matching shingle is still available, or the mismatch will not be visible from the ground
• The decking underneath is dry and solid

Replacement is the right call when

• Shingles are curling, cupping, or losing granules uniformly across whole slopes
• You can see the black fiberglass mat through the surface in multiple places
• The roof is at or past its rated life and you have already repaired it twice
• There are two or more layers and the top one is failing
• Decking is soft in more than a few spots, or the roof deck visibly dips between rafters
• You are getting repeat leaks in different locations, not the same one

Roofing is priced per "square" — one square is 100 square feet of roof surface. A typical Draper home works out to somewhere between 18 and 30 squares once pitch and overhang are counted, which is always more than the home's floor area.

Here is the full sequence for a typical Draper project, so nothing on the day is a surprise.

1. 1

   Free inspection

   We get on the roof, photograph what we find, and check the attic where access allows. Ventilation and decking condition get looked at, not assumed.

2. 2

   Written estimate

   You get an itemized scope, a material selection, a price, and a plain-language explanation of anything we flagged. No same-day-signature discount, ever.

3. 3

   Scheduling and materials

   We book the date, order material, and pull the permit. Material is usually delivered the day before or the morning of.

4. 4

   Protection and tear-off

   Landscaping, AC units, and driveways get covered. The old roof comes off down to the deck. On most homes this is the loudest three hours of the project.

5. 5

   Deck inspection

   With the roof off, we walk every square foot of decking. Soft or rotted sheets are replaced and counted, and you see the count before we cover it up.

6. 6

   Dry-in

   Ice-and-water shield at eaves, valleys, and penetrations. Synthetic underlayment across the field. The house is weather-tight from this point forward.

7. 7

   Flashing and ventilation

   New flashing at walls, chimneys, and penetrations. Ridge vent cut and installed, intake ventilation verified.

8. 8

   Shingles, ridge, and cleanup

   Field shingles, then hip and ridge cap. Magnet sweep of the yard and driveway, debris hauled off the same day.

9. 9

   Final walkthrough

   We walk it with you, hand over the warranty paperwork, and the final payment is due after you have seen the finished job — not before.

Roofing has a low barrier to entry and a long feedback loop — a bad install can look perfect for four years. These are the checks that actually separate companies, in rough order of how much they tell you.

1. 1

   Verify the Utah license, then verify the insurance separately

   Ask for the DOPL license number and look it up yourself. Then ask for a certificate of insurance sent directly from the insurance agent, not a PDF forwarded by the contractor. Both general liability and workers’ compensation. If a worker is hurt on an uninsured crew, the exposure can land on the homeowner.

2. 2

   Require the scope in writing, itemized

   Underlayment type, ice-and-water shield coverage, whether flashing is new or reused, ventilation, the per-sheet decking rate, permit, and cleanup. A one-line quote for "new roof, $14,500" is not an estimate.

3. 3

   Confirm a permit is being pulled

   Most municipalities in Draper require a permit for a full replacement. Skipping it saves the contractor a few hundred dollars and can cost you at resale.

4. 4

   Ask who is physically doing the work

   Employed crew or subcontracted? Neither answer is disqualifying, but a company that will not answer plainly is telling you something.

5. 5

   Ask for the two warranties by name

   The manufacturer warranty covers the shingles. The workmanship warranty covers the installation, and it is only as good as the company behind it. Ask how long they have been operating locally.

6. 6

   Never pay in full up front

   A deposit is normal. Paying the full amount before materials are on site is not, and it removes every bit of leverage you have.

• Financing with approved credit, including options with no prepayment penalty — ask us to run the numbers before you commit to anything.
• Insurance claims for wind, hail, and sudden storm damage. We document the damage, meet the adjuster on site, and bill the approved scope directly.
• Phased work. If the whole roof cannot happen this year, we will tell you which slope is actually urgent and quote that alone.
• Straight repair. If a repair genuinely buys you five more years, that is what we will recommend — it is a better outcome for you and it is how we get the replacement when it is really time.

Deposits are modest and the balance is due after your final walkthrough, not before.

We work throughout Draper — SunCrest, Corner Canyon, Draper Heights, Steeplechase, the Traverse Ridge area, the 12300 South corridor — and everything around Corner Canyon, the Point of the Mountain, Traverse Ridge. Draper has roughly 50,000 residents and sits in Salt Lake County.

SunCrest and Traverse Ridge sit high enough to see materially more snow and much stronger wind than the valley floor, and wind uplift ratings genuinely matter on those homes.