Metal Roofing in South Salt Lake, UT

Standing seam

Vertical panels joined by raised seams with the fasteners hidden underneath. Nothing penetrates the weather surface, which is why it lasts. It is also the most expensive and the least forgiving to install — this is not a system to hire cheaply.

Exposed fastener (corrugated, R-panel, ribbed)

Screws go through the face of the panel into the deck, with a rubber washer sealing each one. Far cheaper, faster, and completely legitimate on shops, garages, and outbuildings. The washers do degrade and the screws need attention every 10 to 15 years.

Stone-coated steel

Steel panels with a granular coating that reads as shingle or tile from the ground. Metal durability with a conventional look, priced between the two above. Popular where an HOA restricts panel appearance.

Small homes and duplexes price low per building. Owners with several properties should ask for a phased multi-building quote rather than pricing them one at a time.

That range assumes a complete tear-off, synthetic underlayment, ice-and-water shield at the eaves and valleys, new flashing, and ridge ventilation. A quote materially below it is usually missing one of those, not finding a cheaper shingle.

Reasons it makes sense in the Salt Lake Valley

• It sheds snow rather than holding it, which reduces ice damming on bench and canyon-mouth homes
• Excellent wind performance on exposed lots — standing seam in particular
• Non-combustible, which matters on wildland-interface properties
• Reflective coatings cut summer attic heat gain meaningfully
• A 50-year service life is realistic, not marketing

Reasons we sometimes talk people out of it

• Two to three times the up-front cost of architectural shingle
• You will not stay long enough to reach the break-even point if you are moving inside ten years
• Snow shedding is a hazard if the roof drains over a walkway, driveway, or entry — snow guards become mandatory, not optional
• Complex rooflines with many valleys and dormers get expensive fast in standing seam
• A poorly installed metal roof is worse than a well-installed shingle roof, and there are fewer crews here who do it properly

For a typical 24-square valley home, that puts a residential standing seam roof somewhere in the $29,000 to $48,000 range, against roughly $11,000 to $18,000 for architectural shingle. Exposed-fastener panel on a detached shop is usually $3,500 to $9,000.

South Salt Lake has more small rental and multi-family property than anywhere else we serve. Owners here care about cost per unit and turnaround time, and we quote that work differently than a single owner-occupied home — often as a phased plan across several buildings.

A lot of the low-slope and flat sections on older South Salt Lake buildings were never suited to shingles in the first place, and those are the roofs that leak reliably every spring.

Housing here is small pre-war and post-war homes, a heavy share of duplexes and small rental properties, and mixed light-commercial buildings. We work throughout the Central Pointe area, the State Street corridor, the Granite area, the 3300 South corridor, and the rest of South Salt Lake — including everything near Central Pointe station.

ZIP codes we serve in South Salt Lake: 84115.

There are two, they cover different things, and only one of them is about us.

• Manufacturer warranty — covers defects in the shingle itself. Usually 25 to 50 years, prorated, and rarely the thing that fails. Most manufacturer warranties are voided by inadequate attic ventilation, which is why we will not skip that step.
• Workmanship warranty — covers the installation. This is the one that matters, because the overwhelming majority of premature roof failures are installation errors, not material defects. Ours is written, transferable to a buyer, and backed by a company that has been in the valley since 2011.
• Enhanced manufacturer system warranties — available when the full system (underlayment, starter, field, ridge, ventilation) comes from one manufacturer and is installed by a certified contractor. These can cover workmanship too. Ask whether you qualify.

We work throughout South Salt Lake — the Central Pointe area, the State Street corridor, the Granite area, the 3300 South corridor — and everything around Central Pointe station, the S-Line streetcar, the State Street corridor. South Salt Lake has roughly 26,000 residents and sits in Salt Lake County.

A lot of the low-slope and flat sections on older South Salt Lake buildings were never suited to shingles in the first place, and those are the roofs that leak reliably every spring.