Metal Roofing in Cottonwood Heights, UT

Standing seam

Vertical panels joined by raised seams with the fasteners hidden underneath. Nothing penetrates the weather surface, which is why it lasts. It is also the most expensive and the least forgiving to install — this is not a system to hire cheaply.

Exposed fastener (corrugated, R-panel, ribbed)

Screws go through the face of the panel into the deck, with a rubber washer sealing each one. Far cheaper, faster, and completely legitimate on shops, garages, and outbuildings. The washers do degrade and the screws need attention every 10 to 15 years.

Stone-coated steel

Steel panels with a granular coating that reads as shingle or tile from the ground. Metal durability with a conventional look, priced between the two above. Popular where an HOA restricts panel appearance.

Steep pitches plus genuine snow load. Extended ice-and-water shield coverage at the eaves is standard here rather than optional, and it is a real line item.

That range assumes a complete tear-off, synthetic underlayment, ice-and-water shield at the eaves and valleys, new flashing, and ridge ventilation. A quote materially below it is usually missing one of those, not finding a cheaper shingle.

Reasons it makes sense in the Salt Lake Valley

• It sheds snow rather than holding it, which reduces ice damming on bench and canyon-mouth homes
• Excellent wind performance on exposed lots — standing seam in particular
• Non-combustible, which matters on wildland-interface properties
• Reflective coatings cut summer attic heat gain meaningfully
• A 50-year service life is realistic, not marketing

Reasons we sometimes talk people out of it

• Two to three times the up-front cost of architectural shingle
• You will not stay long enough to reach the break-even point if you are moving inside ten years
• Snow shedding is a hazard if the roof drains over a walkway, driveway, or entry — snow guards become mandatory, not optional
• Complex rooflines with many valleys and dormers get expensive fast in standing seam
• A poorly installed metal roof is worse than a well-installed shingle roof, and there are fewer crews here who do it properly

For a typical 24-square valley home, that puts a residential standing seam roof somewhere in the $29,000 to $48,000 range, against roughly $11,000 to $18,000 for architectural shingle. Exposed-fastener panel on a detached shop is usually $3,500 to $9,000.

Cottonwood Heights homes carry real snow load and sit right where canyon wind exits Big Cottonwood. Ice-and-water shield at the eaves is not an upsell in this city — it is the difference between a dry ceiling and a February insurance claim.

Snow depth here regularly exceeds the valley floor by a wide margin, and freeze-thaw cycling at the eaves is the single most common source of interior water damage we are called out for.

Housing here is 1970s and 80s two-story and split-level homes, many with steep pitches and shake-look profiles, plus larger homes near the canyon mouth. We work throughout the Fort Union area, the Big Cottonwood Canyon mouth, the Bengal Boulevard area, the Union Park corridor, and the rest of Cottonwood Heights — including everything near the mouth of Big Cottonwood Canyon.

ZIP codes we serve in Cottonwood Heights: 84047, 84093, 84121.

There are two, they cover different things, and only one of them is about us.

• Manufacturer warranty — covers defects in the shingle itself. Usually 25 to 50 years, prorated, and rarely the thing that fails. Most manufacturer warranties are voided by inadequate attic ventilation, which is why we will not skip that step.
• Workmanship warranty — covers the installation. This is the one that matters, because the overwhelming majority of premature roof failures are installation errors, not material defects. Ours is written, transferable to a buyer, and backed by a company that has been in the valley since 2011.
• Enhanced manufacturer system warranties — available when the full system (underlayment, starter, field, ridge, ventilation) comes from one manufacturer and is installed by a certified contractor. These can cover workmanship too. Ask whether you qualify.

We work throughout Cottonwood Heights — the Fort Union area, the Big Cottonwood Canyon mouth, the Bengal Boulevard area, the Union Park corridor — and everything around the mouth of Big Cottonwood Canyon, Fort Union Boulevard, Butler Middle area. Cottonwood Heights has roughly 33,000 residents and sits in Salt Lake County.

Snow depth here regularly exceeds the valley floor by a wide margin, and freeze-thaw cycling at the eaves is the single most common source of interior water damage we are called out for.